Push Switch

Introduction of air tight door in operating room: press the switch

1, must be non-contact proximity sensor, such as non-touch manual sensor or foot sensor, it can be seen that due to the above particularity of the medical automatic door, the ordinary push and pull automatic door standard far does not cover the above requirements, so for the specific medical automatic door standard is very necessary.

2. There must be a connection port for standby power access.

3, the medical automatic door to enhance the clamping function to improve safety, such as must be installed with safety sensors, double open automatic door at the same time the door body must have the resistance after the immediate return function.

4, there must be a delay door closing function and two induction function.

5. There must be a functional interface to automatically start the air shower equipment.

6. The voltage range applicable to the electric control part shall be wide.

7, the electronic control part of the medical automatic door must comply with the national standards on electromagnetic compatibility, open the automatic door to prevent the interference of medical equipment.

8. The motor reducer shall be specially designed to reduce the noise to meet the requirements of the clean room.

9, medical automatic door body, the outer surface of stainless steel plate, electrolytic steel plate, color steel plate, etc., industrial purification door which is made of stainless steel plate, but the cost is higher.Intermediate interlayer USES bubble craft to make, to have the door body that separates radial requirement, intermediate interlayer should have the lead board of certain ply clip in the middle, additional, metope juncture place should have sealing strip enfold.